J
JMHJ
Guest
Last night I finished my second starter teardown this year, on two different bikes. It looks like they spin all the time, unlike a car starter. If that's the case, do they have anything to do with a bike's charging system? I'm learning as I go, and don't know much about the electrical system.
I had to remove the timing chain tensioner on my 450 to get the starter out earlier this year. I cleaned up the starter, and put it back in without replacing anything. When the bike went out of service last year, I was getting more of a clicking noise than the buzzing that another writer described. The cleanup fixed the problem, but I should've replaced the brushes. This has been a dependable bike, and usually fires right up even after it's sat for a while.
The starter on my new 750 failed all of a sudden, with no grinding, clicking (except from the relay or solenoid), or anything. When I opened it up, it was shot, with lots of brush debris inside. A brush plate repair kit and a good cleaning has apparently fixed it. I didn't remove the gas tank, etc. as Clymer suggests to get the starter out, and the tensioner stayed in place as well. This bike can be just a little cantankerous after sitting (2wks in this case), but runs great warmed up and is a lot of fun.
I had to remove the timing chain tensioner on my 450 to get the starter out earlier this year. I cleaned up the starter, and put it back in without replacing anything. When the bike went out of service last year, I was getting more of a clicking noise than the buzzing that another writer described. The cleanup fixed the problem, but I should've replaced the brushes. This has been a dependable bike, and usually fires right up even after it's sat for a while.
The starter on my new 750 failed all of a sudden, with no grinding, clicking (except from the relay or solenoid), or anything. When I opened it up, it was shot, with lots of brush debris inside. A brush plate repair kit and a good cleaning has apparently fixed it. I didn't remove the gas tank, etc. as Clymer suggests to get the starter out, and the tensioner stayed in place as well. This bike can be just a little cantankerous after sitting (2wks in this case), but runs great warmed up and is a lot of fun.