D
ddaum
Guest
Ok, here's the deal: 1980 GS550L, 25K miles, sat for about a year before I got it. Took it to the shop, carbs rebuilt plus tune-up, and general inspection. All lights and gauges work fine and she starts and runs very good on a full battery, but guess what, the bike won't charge the battery. The battery is brand new, and holds a charge fine. After charging at 2amps until full I took it off the charger and tested it about 6 hours later, still holding 13V. I then went over the whole bike removing, cleaning, and preserving all grounds and electrical connections. Then I hooked the battery up and tested it with the leads connected to the bike, no voltage drop, so no short. Started the bike, at 2500 rpm, battery is at 12.67V with the headlight off. No increase in voltage at 5000 rpm. I then continued with The Stator Pages IV with good readings until Test Phase B where I checked the three stator wires for AC Voltage at 5000 rpm. These are my results:
wire1 with wire2: 3.7 VAC
wire1 with wire3: 4.6 VAC
wire2 with wire3: 2.1 VAC
So the stator is at fault. (YAY) My question is: Since I have to replace the stator I want to go with a brand new one and I'm going to replace the R/R with it. Where should I go to buy the most reliable stator and R/R? Should I put a Honda R/R in? Which Honda R/R will work with my bike? When I replace the R/R should I ground it directly to the neg. batt. terminal? Should I also connect the red (+) output wire directly to the (+) battery terminal? (I think I read about someone doing that) Does the new stator come with a new gasket for the cover? If not, where can I order one? As stated before, I have a headlight On/Off switch, after making the repairs (successfully I hope) should I run it with the headlight on at all times?
Thanks for everyone's help you guys are lifesavers!
PS. where can I get a cheap Clymer manual online?
wire1 with wire2: 3.7 VAC
wire1 with wire3: 4.6 VAC
wire2 with wire3: 2.1 VAC
So the stator is at fault. (YAY) My question is: Since I have to replace the stator I want to go with a brand new one and I'm going to replace the R/R with it. Where should I go to buy the most reliable stator and R/R? Should I put a Honda R/R in? Which Honda R/R will work with my bike? When I replace the R/R should I ground it directly to the neg. batt. terminal? Should I also connect the red (+) output wire directly to the (+) battery terminal? (I think I read about someone doing that) Does the new stator come with a new gasket for the cover? If not, where can I order one? As stated before, I have a headlight On/Off switch, after making the repairs (successfully I hope) should I run it with the headlight on at all times?
Thanks for everyone's help you guys are lifesavers!
PS. where can I get a cheap Clymer manual online?