• Required reading for all forum users!!!

    Welcome!
    Register to access the full functionality of the GSResources forum. Until you register and activate your account you will not have full forum access, nor will you be able to post or reply to messages.

    A note to new registrants...
    All new forum registrations must be activated via email before you have full access to the forum.

    A Special Note about Email accounts!
    DO NOT SIGN UP USING hotmail, outlook, gmx, sbcglobal, att, bellsouth or email.com. They delete our forum signup emails.

    A note to old forum members...
    I receive numerous requests from people who can no longer log in because their accounts were deleted. As mentioned in the forum FAQ, user accounts are deleted if you haven't logged in for the past 6 months. If you can't log in, then create a new forum account. If you don't get an error message, then check your email account for an activation message. If you get a message stating that the email address is already in use, then your account still exists so follow the instructions in the forum FAQ for resetting your password.

    Have you forgotten your password or have a new email address? Then read the forum FAQ for details on how to reset it.

    Any email requests for "can't log in anymore" problems or "lost my password" problems will be deleted. Read the forum FAQ and follow the instructions there - that's what we have one for...

  • Returning Visitors

    If you are a returning visitor who never received your confirmation email, then odds are your email provider is blockinig emails from our server. The only thing that can be done to get around this is you will have to try creating another forum account using an email address from another domain.

    If you are a returning visitor to the forum and can't log in using your old forum name and password but used to be able to then chances are your account is deleted. Purges of the databases are done regularly. You will have to create a new forum account and you should be all set.

Reassembling rear caliper - 82 GS1100E

  • Thread starter Thread starter sailorman1617
  • Start date Start date
S

sailorman1617

Guest
Hi, first post here. Great source of info as I resurrect my GS1100E that's been sitting for about 5 years (or more).

Question. I'm rebuilding all of the brake components, including brake lines. When reassembling the split rear caliper, is there a recommended sealant to apply between the two halves? I'm replacing the round rubber seal, but I'd figure it would be a good idea to keep moisture out of that joint. I was going to put a light coating of brake grease between the two halves before bolting them back together. Any other recommendations?
 
Personally I use a thin coat of copper grease making sure it stays on the outside of the centre seal
 
I'm in the middle of rebuilding my rear brake caliper, found this thread on a search. Don't see any reason not to use copper sealant, nobody has chimed in to refute or give another opinion. I'm going to use it.
 
You must log in or register to reply here.

Similar threads

rsquire
1982 GS1100E - My First (Project) Bike
2
Replies
27
Views
736
Grimly
Grimly
sam000lee
77 GS750 <> 82 GS650G Fork Lower Swap
Replies
3
Views
214
sam000lee
sam000lee
G
81 GS1100E... which swingarm do i have??
Replies
14
Views
705
Nessism
Nessism
Chuck78
Radial tires on vintage bikes - Continental etc
Replies
8
Views
827
Grimly
Grimly
hank2
Petcock questions for my '81 GS650GT and unrelated? fuel leak.
Replies
6
Views
465
hank2
hank2
Back
Top