where to start?

[Guest]

ok so i found a chart online and it looks like i need to replace exhaust 1 and 2 with 275's and replace intake 1 and 2 with a 310 and a 330?

does this sounds correct? i looked in the owners manual from basscliffs page but didnt see a chart in there... i also messaged steve but have not heard back from him yet.
so i geuss the next step is to get some shims from the shim pool

Official clearance is .03 to .08 mm. That is .0012 to .0031". So your intake shims are fine and the exhausts are also in spec, but only barely. The shim increment of .05mm is equivalent to .002" so the next smaller shim would put the exhausts at .0035 - which is slightly over spec but given that it will tighten up over time, I'd go with it. You could also run it for a while as is if you haven't time to deal with it immediately.

Get two 2.45 shims for the exhaust and install them soon. Then you'll be good for a long time.

I have a 450T pretty much the same except an '82; great bikes.

 

[Guest]

Thanks for the advice, now that you say it yah I woul want to go smaller not bigger with the exhaust shims since they were tight! (duh) I'm so glad the engine so far seems to be in order my last bike was a nightmare comparatively!

 

[Vmass]

Sorry, just seeing this now. Let me know if you still need shims and what you need, as I am only a few towns away from you and I have a stash of shims. As an alternative, Bettencourts will most likely have what you need. I have purchased some shims from them at very reasonable prices.