.png "Powered by vBulletin")
I need to take the rear pumpkin apart to replace a bushing. I took out the bolts that holds the big plate on behind which are the innards, But I can't get the plate off. I see a couple of threaded holes on the plate could they be for some sort of a puller ? Has anyone taken a pumpkin apart who could point me in the right direction ? Thanks.
-
-
Sorry, no experience taking apart one of the final drive units so can't help with your question. I can say that these units are extremely durable and rarely fail or leak, and because of that you can buy a good-used unit for cheap so you might want to consider that. I happen to have a decent unit from a GS1000 with 28k miles that you can have for shipping cost if you want to go that route. Send me a PM if you want to discuss.Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection -
see page# 121 (illustration# 8-6)
To remove the final gear bearing cover
from the housing, use two 6 mm screws;
screw them into the holes provided and
draw the cover off evenlyComment
Comment