no kidding. . . .
Announcement
Collapse
No announcement yet.
The usual smoking question
Collapse
X
-
Nuggets
-
bbjumper
When I did the cylinders on my G last Spring (valves, valve seals, rings and hone) I followed the advise on this site
and just rode the pi$$ out of it as per the article. Got 8K on the engine since and all compressions are in the 160 range and she only uses about 8 to 12 oz. of oil between changes no matter how I ride it. Runs like a new one.
Comment
-
Nuggets
-
Forum LongTimerGSResource Superstar
Past Site Supporter
Super Site Supporter- Mar 2006
- 35642
- Torrance, CA
That mototuneuse recommendation is a little over blown in my view. Millions and millions of engines are put into service each year and only a few have problems with rings not sealing, and very few are broken in like those guys recommend.Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection
Comment
-
bbjumper
Originally posted by Nessism View PostThat mototuneuse recommendation is a little over blown in my view. Millions and millions of engines are put into service each year and only a few have problems with rings not sealing, and very few are broken in like those guys recommend.
Comment
-
Nuggets
re
Well like I said the next day I have off Ill just take for a good 5 hour ride down some awesome roads and see what happens. If not then Ill redo it. I live in Florida where it rains for 5 months straight during the late summer so if need be Ill do it then.
Comment
-
bbjumper
This is another good resource.
Comment
-
Forum LongTimerBard Award Winner
GSResource Superstar
Past Site Supporter- Jul 2005
- 15153
- Marysville, Michigan
Originally posted by Nuggets View Postno kidding. . . .
You need to check everything when reconditioning an assembly. Again, did you check the valves and valve guides as shown in the service manual and did you check to make sure you didn't damage the valve stem seals after installation?
Comment
-
I was just yesterday looking at / cleaning up a head for a 750 and as I was looking things over I see that it has a crack on the #1 cyl intake valve guide, what are the chances you have the same problem?1984 GS1100GK newest addition to the heard
80 GS 1000gt- most favorite ride love this bike
1978 GS1000E- Known as "RoadKill" , Finished :D
83 gs750ed- first new purchase
85 EX500- vintage track weapon
1958Ducati 98 Tourismo
“Remember When in doubt use full throttle, It may not improve the situation ,but it will end the suspense ,
If it isn't going to make it faster or safer it isn't worth doing
Comment
Comment