GS1000E Head Gasket Question

[Guest]

Hi everyone.

Please can someone help, I'm rebuilding my 1978 GS1000E engine and its time to install the cylinder head. The head gasket I have has large holes around the outer four studs with a copper seal. My question is that there are also four
O rings with the gasket set that appear to fit these larger holes on the head gasket..it this correct?

I know that this is my first post but really would appreciate any advice.

Thanks in advance

Mike

[rustybronco]

Hi everyone.

Please can someone help, I'm rebuilding my 1978 GS1000E engine and its time to install the cylinder head. The head gasket I have has large holes around the outer four studs with a copper seal. My question is that there are also four
O rings with the gasket set that appear to fit these larger holes on the head gasket..it this correct?

I know that this is my first post but really would appreciate any advice.

Thanks in advance

Mike

The originals used a seal which fit inside the copper washers.

[Trumpeter]

Brilliant, thanks very much for your help.
I've been searching the internet for hours and you answer in minutes!

Thanks again

[rustybronco]

Well now that you know where we live....