Announcement

Collapse
No announcement yet.

Just a little lug at higher speeds

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
    #1

    Just a little lug at higher speeds

    Hey all. I have an'83 gs850, 35xxx miles on it. I bought it about two years ago, and have ridden it several thousand miles. Recently, I had to replace the starter. Took off the carbs, pulled out the starter, put a new one in, etc. I didn't make any adjustments to the carbs, but did pull out the air filter and cleaned it, oiled it and put it all back together. Ever since then I've noticed a slight lag at speed around 55-60 mph or higher. It isn't very prominent (might even be overlooked by someone not mechanically inclined) but its there. Either it isn't noticeable at lower speeds or it doesn't happen then, because I've only noticed it when out on the highway. Any help that you all can offer would be much appreciated!
    Tags: None
    #2
    My questions to you would be, is the chrome and black end cover on the air box well sealed, are the boots from air box to carb inlets properly attached to the carb bodies and were the carb adaptors to the cylinder head nice and soft?

    (I think so doesn't count)
    De-stinking Penelope http://thegsresources.com/_forum/sho...d.php?t=179245

    http://www.thegsresources.com/_forum...35#post1625535

    Comment

      #3
      When you took the carbs off you could have caused some sediment in the bottom of the bowls to break off. Could be some clogging in the carbs going on. Probably time to pull the carbs and do a rebuild on them. Like it was mentioned before, check and replace any and all rubber boots and seals that are brittle, cracked, and hard. An air leak can cause a lean problem hence causing your lag.
      sigpicMrBill Been a GSR member on and off since April 2002
      1980 GS 750E Bought new in Feb of 1980
      2015 CAN AM RTS


      Stuff I've done to my bike:dancing: 1100E front end with new Sonic springs, 1100E swing arm conversion with new Progressive shocks installed, 530 sprockets/chain conversion, new SS brake lines, new brake pads. New SS fasteners through out. Rebuilt carbs, new EBC clutch springs and horn installed. New paint. Motor runs strong.

      Comment

        #4
        Tested all of the boots with wd-40 and they're all sealed up tight, and nice and soft. The airbox seems to be all sealed up, and the seals on the air filter are soft and appear to be in fine condition as well. I'll have to pull off the carbs tonight as see if there is any clogging.

        Comment

          #5
          Make sure the airbox to carb boots are attached properly. A lot of times the two inner most boots won't fit completely on the carbs. If that is the case, let us know.
          De-stinking Penelope http://thegsresources.com/_forum/sho...d.php?t=179245

          http://www.thegsresources.com/_forum...35#post1625535

          Comment

            #6
            Originally posted by rustybronco View Post
            Make sure the airbox to carb boots are attached properly. A lot of times the two inner most boots won't fit completely on the carbs. If that is the case, let us know.
            I see he didn't report back in so I'll top the story off. You were right, the inner boots could have been put on better and also the snorkel for the airbox was not attached anymore, just kind of sandwiched in there. Took airbox off, everything reattached correctly and it's running normally again.

            Comment

              #7
              Sorry all, busy past couple days, but like nejeff said, its all fixed up and running well again! Thanks for the help!

              Comment

              Previous template Next
              Working...
              X