Announcement

Collapse
No announcement yet.

Cold Cyjinders

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Cold Cyjinders

    Just wired up my coils and did a valve job and now I have I have three cold cylinders on my 83 GS1100E. The bike did run after I did the valve job but just wired the coil and rev limiter and now try to start and no start.Touch number on pipe and it was warm but the other three were cold. What could this be???????????? any help!!!!!!!!!!!!!!

    #2
    What do you consider "a valve job"?

    To me, a "valve job" is removing the valves, resurfacing the faces of the valves, resurfacing the seats in the head and possibly replacing the valve guides, then putting it all back together with new seals on the valve guides.

    Some people call checking the valve clearances "a valve job", so what all did you do?

    What all was involved in "wired up my coils"? And then there is the "rev limiter" part. Obviously, this bike is not completely stock, so it would help if we knew what all has been done.

    .
    sigpic
    mine: 2000 Honda GoldWing GL1500SE and 1980 GS850G'K' "Junior"
    hers: 1982 GS850GL - "Angel" and 1969 Suzuki T250 Scrambler
    #1 son: 1986 Yamaha Venture Royale 1300 and 1982 GS650GL "Rat Bagger"
    #2 son: 1980 GS1000G
    Family Portrait
    Siblings and Spouses
    Mom's first ride
    Want a copy of my valve adjust spreadsheet for your 2-valve per cylinder engine? Send me an e-mail request (not a PM)
    (Click on my username in the upper-left corner for e-mail info.)

    Comment

    Working...
    X