No spark on any cylinder

[Guest]

I bought a bike in pieces and am putting them back together. The coils that came with the bike, one had a trashed boot and the other had a severed line so I bought a pair on ebay that the seller claimed worked.

I have verified that each wire has continuity to the ICU and that the coils are both getting 12v. Ground is also connected. I have not decided the signal generator or the ICU and before I just start ordering new dynatek parts, I'd like to isolate the issue.

Where can I go from here. Again, not getting spark on any cylinder.

[Nessism]

I'd go though the factory Suzuki service manual and perform the checks they detail. Basscliff has a free manual download if you don't already have one.

[Sphynx88]

Thanks for the words Ed, I actually just figured it out. While I measured continuity to the 12v, I didn't actually see 12v. Fixed that and the bike fired right up!!!