Announcement
Collapse
No announcement yet.
Cil #3 dont burn mixture
Collapse
X
-
Forum GuruCharter Member
GSResource Superstar
Past Site Supporter- Oct 2002
- 8858
- Angeles Forest, So.Calif./Red rocks of Southern Utah.
Re: possible coil problem... why would installing a new plug into the cap make the fat blue spark return as he says? A fouled plug can obviously deter good spark, but if the coil really is weak, then installing a new plug would still show a weak read, and #2 should also have a weak spark and similar problems.And on the seventh day,after resting from all that he had done,God went for a ride on his GS!
Upon seeing that it was good, he went out again on his ZX14! But just a little bit faster!
-
Forum GuruCharter Member
GSResource Superstar
Past Site Supporter- Oct 2002
- 8858
- Angeles Forest, So.Calif./Red rocks of Southern Utah.
After your compression check and carb synch, etc, (if the compression is good) let us know what happens.
To test the choke plungers for sealing, you would have to blow into the passage that leads to the choke starter jet/tube. With the plungers down, no air should be heard to escape. Your fouling at 1/4 and 1/2 throttle positions wouldn't be choke related. The choke is bypassed as soon as the thottle is opened that far. There can be a minimal mixture change, but not enough to cause your problem.
You foul the plug at warm up with the choke because the mixture is already too rich in that cylinder. Either from a carb mixture problem, weak spark, or poor compression.
Is 24mm the factory setting for the floats. Also, the measurement should be done with the bowl gasket removed.And on the seventh day,after resting from all that he had done,God went for a ride on his GS!
Upon seeing that it was good, he went out again on his ZX14! But just a little bit faster!
Comment
-
Anonymous
Originally posted by KEITH KRAUSERe: possible coil problem... why would installing a new plug into the cap make the fat blue spark return as he says? A fouled plug can obviously deter good spark, but if the coil really is weak, then installing a new plug would still show a weak read, and #2 should also have a weak spark and similar problems.
The carburators would be the only other possibility (if compression is good). I thought he said he already went through them. That's not saying they are good, since most people use a spray can cleaner on them. The only way to make sure passages are open is to dip them and use an air compressor. If that hasn't already been done, that would be my next step.
I'm not a carburetor expert Keith. I defer to you and others when it comes to them.
Comment
-
Forum GuruCharter Member
GSResource Superstar
Past Site Supporter- Oct 2002
- 8858
- Angeles Forest, So.Calif./Red rocks of Southern Utah.
Originally posted by SwannyI'm not a carburetor expert Keith. I defer to you and others when it comes to them.And on the seventh day,after resting from all that he had done,God went for a ride on his GS!
Upon seeing that it was good, he went out again on his ZX14! But just a little bit faster!
Comment
Comment