Announcement

Collapse
No announcement yet.

GS 1150 ES exhaust pipe warning ...

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    GS 1150 ES exhaust pipe warning ...

    I have a 84 GS 1150ES with a Yosh 4-1 pipe now, but the the pipe I had before the Yosh pipe was a Kerker 4-2 pipe which was designed for a GS 1100 in mind because the header pipes were smaller than the exhaust port!! Not good for exhaust flow I noticed when I took it off to replace an exhaust gasket and saw carbon on the pipe surface that mates to the gasket... It was about an 1/8 inch wide black band around the outside edge of the mating surface..... The inside diameter was much smaller compared to the Yosh..... The Yoshimura pipe made it run a whole lot better Don't know if Kerker just figured the ports were the same size ... :roll:
    Did anybody notice this? I bought the Kerker pipe back in '86 and the Yoshimura pipe around 1994 ...


    Alan
Working...
X